Clean the vents in the back with a cotton swab. The fan will calm down and shut off automatically after the sensors in the system think that the inside is clean enough. You’ll have a ton of dust caked on to the vents. Use a clean cotton swab to remove the dust by running the swab between each panel.
How do you take the fan off a PS3?
Lift the top cover from its rear edge and rotate it toward the front of the PS3. Remove the top cover. There is a plastic hook located in a hole on the top back right hand side corner. Carefully push the plastic hook a bit front the rear of the machine with a spudger to release the rear right of the casing.
Why is PS3 fan so loud?
If the PS3 gets close to critically overheating, the fan will begin begin working as hard as it can to keep the system from crashing entirely. Under normal circumstances, this shouldn’t happen often, if at all, but if your PS3 is old or if it’s not in an ideal location in your home, it could overheat.
How do you access the fan on PS3?
Hold down the “Eject” button on the front panel of the PS3 and at the same time turn on the power switch. You should hear the system powering on and all the fans running.
How do I stop my PS3 from overheating?
first and formost make sure you blow out the ps3 from time to time. too much dust can block airflow and cause overheating. after playing for extended periods of time going to the main menu and letting the unit cool off is also a good idea. i would cut the whole rear out of that shelf so the hot air can escape.
What tools do you need to take apart a PS3?
Tools Featured in this Teardown
- Phillips #1 Screwdriver.
- Spudger.
- T8 Torx Security Bit Screwdriver. $5.99.
How do I unplug the fan on my PS3?
Simply pull the 3 wire fan connector (brown-black-grey) straight up to unplug it from the mainboard. There is no locking mechanism. On most PS3 models beside CECHA01/B01/C01/E01 this connector is on top of the mainboard, thus eliminating most of these disassembly steps.
How do I remove the front cover of a PS3?
Place your palm on the PlayStation 3 logo and slide the plastic front cover towards you and off of the outer plastic shell. Set it aside. Remove the metal receiver that held the torx screw you just removed.
What happened to the original PlayStation 3 60GB?
This is a teardown of an original launch 60GB PlayStation 3 system. One of the best units out there that had backwards compatibility and the card readers. Sadly this unit has a GPU a problem so it’s broken. Edit: Nickname fix, formerly Karasumachitose. Apologies to any inconvenience this causes. This teardown is not a repair guide.
How do I repair my PS3?
To repair your PlayStation 3, use our service manual. There she is, one of the two original PS3 models available at launch (60GB). It’s got PS2/PS1 backwards compatibility and a multi-card reader.
