From DD-WRT Wiki Wireless Bridging is used to connect two LAN segments via a wireless link. The two segments will be in the same subnet and look like two Ethernet switches connected by a cable to all computers on the subnet.
How do I access DD-WRT Repeater Bridge?
Go to the wireless tab.
- Choose Repeater Bridge under wireless mode.
- Match your SSID and channel settings exactly to the main router you will be connecting to.
- Make sure bridged is selected.
- Click Save.
How do I use DD-WRT in bridge mode?
DD-WRT Router Setup for Wireless Repeater Bridge
- Navigate to Security > Firewall.
- Navigate to Services > Services.
- Navigate to Wireless > Basic Settings.
- Select Add in the Virtual Interface area.
- In the Wireless Physical Interface settings for the 2.4GHz network set the Wireless Mode to Repeater Bridge.
Should I put my router in bridge mode?
When two NAT devices are connected in series (for instance a modem with built-in NAT capabilities is connected to a router which is also a NAT device), it is advisable to configure your modem in bridge mode to avoid conflicts.
How do I use DD WRT in bridge mode?
How to configure repeater bridge for DD-WRT?
For a secondary router running DD-WRT, the wireless mode must be configured as Repeater Bridge. It will connect to a primary router in AP mode (DD-WRT default) with DHCP Server enabled. Any type of VAP (Virtual Access Point) on the host should work, including a WDS-AP (Atheros) or any VAP including on another RB, but can depend on the host router.
What is a repeater bridge and how to use it?
In order to allow wireless clients to connect to the secondary router, a Repeater Bridge is necessary. A Repeater Bridge allows wireless and wired clients to connect to the secondary router. It also allows the secondary device to connect to the main device wirelessly. How To Set Up A Repeater Bridge On Your DD-WRT Router
How do I reset my DD-WRT router to default settings?
Reset to Factory Defaults on the secondary DD-WRT router. Perform a hard reset if needed. Hook up the secondary router with an Ethernet cord or just as a wireless client. Open the address in your browser to access the DD-WRT GUI. Wait 30 seconds and then power off the router and power it back on.
What is DD-WRT and how does it work?
With DD-WRT, a wireless bridge connecting two LAN segments is possible using a wireless link. The two segments are on the same subnet, allowing broadcasts to reach all machines. DHCP clients in one segment are able to get their addresses from the DHCP server in the other segment.
